Lost bath plug what can i use?

12
Wiley Nikolaus asked a question: Lost bath plug what can i use?
Asked By: Wiley Nikolaus
Date created: Tue, May 4, 2021 9:04 PM
Date updated: Wed, Jun 29, 2022 7:31 AM

Content

Top best answers to the question «Lost bath plug what can i use»

  1. How Do Bath Plugs Work?
  2. Ways to Block a Bathtub Drain. Use a Small Plastic Cup. Use Plumber's Putty. Find a Jar Lid of the Same Size With the Drain Hole. Use a Toilet Plunger. Plug the Drain With a Washcloth Stuffed Inside a Plastic Bag. Tape the Drain Hole…
  3. Some Considerations to Keep in Mind.
  4. Conclusion.
  • If you want something more permanent with your lost or damaged stopper, you can use a marine drain twist plug. These are made from plastic and have a rubber seal at one end. They twist into your bathtub drain, and they can be removed when you want to take a shower or fill the tub with water again.

10 other answers

Use a Toilet Plunger If you have a toilet plunger, it can serve as a makeshift plug for your bath drain. All you have to do is to clean the rubber end of it with some soap and water and then set it over the drain hole in the tub. Press down on it to seal the drain and remove the wooden handle.

Bathtub drains usually have a standard size and you can easily find a replacement bathtub plug for your drain. If you think your drain is larger in size though, you will have to take out the drain using a screwdriver. Do that very carefully though, not damaging it as a custom plug might need exact measurements to be built.

Create a makeshift drain plug using a washcloth or small sponge inserted into a small plastic bag. Twist a wet washcloth tightly or wet a sponge that has been rolled to fit the drain. Place the cloth or sponge inside a plastic sandwich bag. Squeeze as much air out as you can and zip it closed or use a rubber band to secure it.

Washcloth in a Bag A washcloth is the perfect item for a DIY bath plug. Tuck a flat washcloth into a plastic bag. Squeeze or suck most of the air from the bag, sealing the ends if it's a sandwich or storage bag, tying the ends in a knot or using a cable tie to seal the washcloth in the bag.

Then you can remove the plug. Proceed carefully—sometimes a valuable can get hooked on the bottom (or against the side) of your drain plug. Removing it forcefully could cause the object to sink further down the drain. If it's been a while since you’ve cleaned your bathroom sink, the drain plug might be dirty and bring debris up with it ...

Have DH scrub it down with a cleaning agent (I prefer Lysol because it kills germs but isn't as strong as bleach) and sink into a nice warm bath. You're not supposed to use any bubble bath stuff as it can agitate your vagina (I think that goes for your entire pregnancy). But some candles, a hot bath and a book can really brighten your day.

If you can, we still suggest that you use a rubber universal sink plug (like the one pictured in step 5) for just one reason: it seals sinks better. Especially during clothes washing when you’re likely to bump the plug a lot.

GFI's are receptacles that are usually used around wet locations to prevent electrocution in wet/water/damp locations, its a safety measure. Go around the bathroom and reset all the GFI's. There is...

use a small hand towel or flannel and shove it into the plus hole. or a small cloth that you use to polish with or wash dishes with and it will become saturated with water. wont be 100% water tight but will work for a fair amount of time just fill bath up slightly more to make up for amount lost like every 5 mins.

If you lose the plug “at term,” i.e., at around 36 weeks, there’s nothing to avoid. However, ... or sitting in a pool or bath if you lose your plug earlier than 36 weeks.

Your Answer